Re-chambering A Rifle

Re-chambering A Rifle

The chamber of almost any rifle can be found from the barrel, which is threaded to the rifle receiver. The process of re-chambering a rifle contains selecting a larger cartridge in comparison towards the one you’ve used before to be able to manage to take away the metal, enlarging the chamber in order to fit the new cartridge. It is advisable never to change calibers because in so doing, you’ll need to re-bore the barrel of your gun. In the great majority in the cases, the process of re-chambering requires replacing the ejector around the bolt. This article will show you in five simple steps the best way to re-chamber a rifle. Here are things you will need just for this: gun vice, a rifle barrel wrench, a head-space gauge for the new cartridge, drill bit matching the newest chamber specifications, calipers (accurate to within 1/10,000 of an inch), drilling lubricant/coolant as well as a new ejector pin that matches the brand new cartridge.

The starting point you should accomplish is usually to remove the rifle?s barrel from your receiver by using your rifle barrel wrench we mentioned before. For this step, you will require extreme torque along with a gun vice, the receiver in the rifle have to be held securely and firmly.

Step number 2 is usually to center the rifle chamber, exactly dead center by using your personal drill. The recommended tolerance when completing this technique is at most all cases 1/10,000 of an inch (or better).

Next, you have to be very attentive when measuring the quantity of depth required for the modern chamber and be sure that you lock the drill stop so that you can avoid the specific situation when the bit exceeds the utmost chamber depth for your new cartridge. During this rather difficult step, the tolerance is around 1/10,000 of an inch, or better.

Step number four includes slowly drilling the receiver while at the same time by using a lubricant/coolant to be able to keep up with the temperature only you are able to. If the metal temperature would be to high, it’ll reduce the strength from the chamber walls and most likely make a chamber that’s incompetent at withstanding abdominal muscles high pressures which are manufactured by an ordinary rifle cartridge.

Your last step is always to reattach the rifle barrel/chamber to the receiver utilizing the head-space gauge located in to the chamber, in order to be sure that the adequate head spacing is guaranteed with the installing of the brand new cartridge. After doing so, you must tighten the barrel until finally the head-spacing gauge permits the bolt to shut securely. This head-spacing gauge assures how the bullet shot through your rifle is backed up by the bolt which means the possibility of excessive expansion with the bass cartridge will be highly unlikely.

After completing all of the above steps, it is now time to test a new chamber. We recommend that you simply start with light loads and gradually work your way as much as better ones. The process of re-chambering any type of rifle is very demanding mainly because it requires the person that can this to remain within the very tight tolerances we mentioned at the beginning of the article. For those of you which might be not able to complete this, it is recommended to take the gun to an experienced gunsmith.Article Source: detailed information about hunting firearms and scopes at us at our online page – .

Advertisements

Trả lời

Mời bạn điền thông tin vào ô dưới đây hoặc kích vào một biểu tượng để đăng nhập:

WordPress.com Logo

Bạn đang bình luận bằng tài khoản WordPress.com Đăng xuất / Thay đổi )

Twitter picture

Bạn đang bình luận bằng tài khoản Twitter Đăng xuất / Thay đổi )

Facebook photo

Bạn đang bình luận bằng tài khoản Facebook Đăng xuất / Thay đổi )

Google+ photo

Bạn đang bình luận bằng tài khoản Google+ Đăng xuất / Thay đổi )

Connecting to %s